Jump to content

Recommended Posts

Hello,

i have source code of clamav and i am also using clamav on my system, clam av loads db each time a new scan is performed, how could i change it to load only once for multiple scan, i have tried making clamav engine static and not re-compile for multiple scan but now it is ony reading data not scanning how could i  modify it in the right way,  any help would be appreciate.d

Share this post


Link to post
Share on other sites

Hello RajneeshMaster,  I'm not sure if that's possible to configure the .db files only once for multiple scans but here is a link for the ClamAV Documentation page. http://www.clamav.net/doc/install.html Hopefully the information you seek can be found there.

 

I wish I could be more helpful but this Immunet forum is not an official Support site for the ClamAV software. You may have to contact the ClamAV team directly via email if you find no relevant information at the Documentation URL. Here is a link for ClamAV contact information. http://www.clamav.net/contact.html

Cheers, Ritchie...

Share this post


Link to post
Share on other sites

Hello RajneeshMaster,  I'm not sure if that's possible to configure the .db files only once for multiple scans but here is a link for the ClamAV Documentation page. http://www.clamav.net/doc/install.html Hopefully the information you seek can be found there.

 

I wish I could be more helpful but this Immunet forum is not an official Support site for the ClamAV software. You may have to contact the ClamAV team directly via email if you find no relevant information at the Documentation URL. Here is a link for ClamAV contact information. http://www.clamav.net/contact.html

 

Cheers, Ritchie...

thanks

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×